Jump to content
Ultimaker Community of 3D Printing Experts

lbullerman

Dormant
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    US
  1. I've acquired an UM2 with my new job. We've done some printing, played around, and had some strange issues -- material would simply stop extruding, feeder would be clicking away. So, I figured since I had a spare hot-end kit, I might as well at least replace the PTFE coupler. I've just taken the thing apart, and found that the nozzle had quite a coating of burnt media up on the nozzle block itself (nozzle was clean, as we'd cleaned it a few times). I was also unable to extract the temp sensor from the nozzle block (heater came out fine). So, it was quite the teardown to pull the sensor cable a
×
×
  • Create New...