Davj90

Ho provato a rimontarlo eseguendo pari pari come dice il manuale ma il problema persiste,se lo muovo a mano verso l'alto è un po piu duro rispetto a quando si muovo verso il basso..

Salve a tutti,ho un problema con la ultimaker original dopo aver montato il heated bed kit,a una altezza che varia da 9 a 11mm il pezzo risulta ''tagliato'' come se fosse sbagliata l'altezza a cui è stato estruso il materiale.Ho provato a sistemare meglio i due cuscinetti lineari,ricalibrare la stampante,stampa con vari software/materiali ma senza risultato... Foto:https://drive.google.com/file/d/0ByAq3NQxmUMpaDhOckNvUmpURjg/view?usp=sharing https://drive.google.com/file/d/0ByAq3NQxmUMpN0t3WnBPQ1R6Qk0/view?usp=sharing https://drive.google.com/file/d/0ByAq3NQxmUMpSWVldTZReElWRjA/view?usp=sharing Grazie.

Hello everyone,I lately upgraded my Ultimaker Original with the new heated bed kit. After assembling it, updating the cura settings (I'm using now Cura 14.09) and installing the new Marlin Firmware on the printer. After about twenty layer is the piece '' cut '' as if it were the wrong height to which the material has been extruded. I noticed that the plan goes down too easily for weight guilt, I can take him down just push it with one finger. I tried to better accommodate the two '' bearings '' that should prevent this but to no avail ... i do not think it's a problem of a bad calibration of the motors because I think everything should be the object of phase. It does so with all the materials ABS, PLA ... photo: https://drive.google.com/file/d/0ByAq3NQxmUMpQ0wwblhpYW9neGM/view?usp=sharing (sry for my english)

Same bug here,i user a Ultumaker Original.