Jump to content

Arwen

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    NL
  1. Hi all, I have an Ultimaker 2+ X, now a year and a half old. It's running almost constantly and I've had problems, but nothing surprising, except for today. I re-leveled the bed, because I had a jam earlier and it was time anyway, and I started a print. I had leveled it to be pretty tight to the plate; about 100 micron space, as I always do. And it started extruding about 6-10 mm ABOVE the build plate, basically in mid-air. I did the whole thing 2 more times and exactly the same thing happened. (No new Cura, no new firmware. Cure 15.04.6) Anybody had the same thing? What can be done?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!