Jump to content
Ultimaker Community of 3D Printing Experts

glucaizzo

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    IT
  1. Hi, thanks for reply; i also suspected a power issue, i already tried to powerup fans, temp-up plate and nozzle, in this way seems to remain all powered on; seems to go off/on after a bit of stress when all parts are in movement, i also noticed the leds fade intermittently a bit before the issue. I see the nozzle fans, but i I can hear other fans, probably internal, can i access to them ? What other can i check ? Eventually, can i replace these parts ? regards, Gianluca.
  2. Hi, i've always printed with no problems. today my UM2+ started to print normally, after 1 or 2 minute printing stopped to work and a reboot/reset occurred, no error messages. retried many times with no success. any ideas ? regards Gianluca
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!