UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Keine Materialzufuhr nach ein paar Layern.
in Deutsch
Posted · Edited by Guest
Hallo
bin am verzweifeln, vielleicht hat jemand einen Rat.
Situation:
Nach ein paar sauberen Layern spuckt die Düse nur noch punktförmig Material aus. (Bilder)
Meiner Meinung nach kommt nicht mehr genug Material nach???
Der Fehler tritt immer bei der gleichen Höhe des Drucks auf.
Was hab ich schon ohne Erfolg getan?
- Materialwechsel
- Anpressdruck Feeder geändert, in alle Richtungen
- Düse getauscht
- Temperatur verstellt => bei 230 ° klebt die Düse am Druck fest => Error
- Material Flow erhöht
Ausstattung:
Ultimaker 2
Olson Block
Dauerdruckbett
Standart Feeder