Hi.
First Post, first question
I'v been reading all posts about warping. But cannot find a solution.
THe problem is only in the Layer that touches the Hot Bed. The rest of the print is perfet.
Tryed with Low bed temp, brim, using a heater arround the printer, but always the borders warps and the first layer seem to be "melted".
Setting.
Printer Prusa I3-x
No vents.
Hot Bed to 50º (tried till 95º)
Filament temp 240º
Printed directly to Hot Bed (METAL, not glass)
Using Hair Spray to fix it to bed.
Speed 50mm/s
Layers at 0.1mm
Any Idea?
Regards