UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Hello, up to recently I've been using Slic3r for all my prints, and decided to give a try to the new Cura version and found out it was quite an improvement. However, there's a feature that it hasn't (Or I didn't find) that is infill only where needed.
What it does is that it only generates infill for the parts where it's needed as support for the 'roof' of the model.
There are a few prints where I don't need the piece to be so strong, but I need to print it faster, and with less material.
Infill only where needed [Feedback]
in UltiMaker Cura
Posted
Hello, up to recently I've been using Slic3r for all my prints, and decided to give a try to the new Cura version and found out it was quite an improvement. However, there's a feature that it hasn't (Or I didn't find) that is infill only where needed.
What it does is that it only generates infill for the parts where it's needed as support for the 'roof' of the model.
There are a few prints where I don't need the piece to be so strong, but I need to print it faster, and with less material.
Thank you for your attention.