langley51
-
Posts
6 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by langley51
-
-
I am using Cura and I am now having problems with my nozzle lifting up before it prints. My bed has auto level and everything is good, when I load a gcode
the printer and start printing, it will lay down the line then it will lift up making it too high now. I thought it was my printer , so I loaded an older file , and it printed alright. Read something about the error in Cura issues.
I am now not able to print anything that is sliced in Cura, is there a fix for this or do we go back several revisions.
Thanks
-
Using Cura 4.8.0
-
I am printing 3d plane parts / fuselage parts and I am getting alot of thin areas with pin holes. I am using ESUN PLA+ ,
temp is 220 nozzle , bed 60
Layer height: .25
Shell: wall line count 1
Cooling : enabled Fan speed : 30
220 nozzle temp , bed : 60.
Infill : 0
Print speed: 50
Travel : enabled retraction
Mesh Fixes: union overlapping volumes (checked)
Special Modes: Surface mode normal
-
I have been using Cura 4.8.0 and it has been working good on files from Thingiverse, however now when I work up a file and go to print my nozzle height has changed to a higher level.
What settings do I check to see why now my nozzle is higher than before when all other files have printed.
Thanks
-
I worked up a file to print from Cura, went and ran a different file and now my nozzle is too high from table. What would change that from the last file?
Thanks
Cura 4.8.0 & 4.9.0
in UltiMaker Cura
Posted
Morning Ultimaker developers ,
I was using Cura Slicer 4.8.0 and I downloaded the new Cura Slicer 4.9.0 and started having problems printing . I tried several different setting as I thought I had made some changes by mistake. After 5 or 6 attempts I started to reach out to Youtube video sites & Ultimaker (I sent you a email) to see what was going on. I was trying to print items like the "Flexi Pterodectyl & Dragon". The flexi parts seem they were bonded together with other parts and was not able to flex, could not understand what was going on as I had printed flexi butterflys no problem before. Then I remembered I had downloaded the Cura 4.9.0, so as an experiment I reinstalled a version of Cura 4.8.0 , sliced the same file and guess what, the flexi is printing fine now with Cura 4.8.0.
So, it there a bug or some setting I need to turn off / on in Cura 4.9.0 that will eliminate this problem?
I am using a Lotmaxx SC10 Shark and I have a new Anycubic Chrion, I am kinda leary now in using Cura 4.9.0 with my printers now.
Below view the 4.9.0 Cura vs 4.8.0 Cura ( 4.8.0 works fine.. 4.9.0 not printing good, used same file to print in both versions of Cura)
Looking for a reply...
Thanks, AL