Dear co-ultimakers,
I know you mean well, but this is not really the help I need. As i said before, I m not new to 3D printing. I have been in design engineering for over 10 years now. I have been using 3D print hubs for about the same time. I have worked with a resin printer (Form 1) was a while in my previous job and a Flashforge machine as well. I have never worked with Cura and Ultimaker and yes, that's frustrating the hell out of me. So please, read my posts? As I said, I did NOT change many settings, just increased the speed of the "standard" settings by 5mm/sec so it would fit into one working day. The print shown below is the same print, printed with half the supports and it is fine. SAME PRINT, STANDARD SETTINGS. I DID NOT CHANGE THE SETTINGS FOR THE THIRD PRINT, AND I GOT THE PARTS AS IN THE LAST PICTURE. What is happening? Could it be the Cura update? I did not update to 15.04.5 yet, though Cura itself says it's the latest version. Which is odd, but ok. If only that was the worst of my problems...