webliya

Well, After trying a couple of prints. My settings for Colorfabb XT are as follows. I get perfect results with it. Very strong material. I used RED which is very eye catching. Layers: 300 micron (0.3 mm) First layer: 96% and 30% speed with 200% width Speed: 60 mm/sec ( I also tried up to 120 mm/sec and result is not bad). For transparency use 20-30 mm/sec with NO FAN. Top & Bottom solid layers: 6 Outline/parameter shells: 3 Always use skirt Infill: Rectilinear or honeycomb Infill percentage: Depends on usage of the piece 50% to 100% (100% gives rock solid pieces) Temp Extruder: 250 degrees Celsius (I tried 240 to 260 by 5 increments 250 is the best) Temp Bed: 70 degrees Celsius (sticks perfect on kapton band) and removes easily. No warping. FAN: Always 100% on. Color changes depending on fan on or off and even with its speed. For transparency use NO FAN. So go on try these. You will love Colorfabb XT. Rock solid, shinning, easy flow. You can see some of the parts I printed with Colorfabb XT red here.