Jump to content
Ultimaker Community of 3D Printing Experts

DGTalic

Member
  • Content Count

    7
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  1. DGTalic

    What material to use?

    Many thanks to both! Greatly appreciated.
  2. DGTalic

    What material to use?

    Hi. I need to create and print an object that will be in water for very long periods of time. Residual waters. It is basically a mesh that holds together a sponge that acts as a water filter. Any suggestions on what material to use? Would PLA work just fine? See image attached. Many thanks in advance.
  3. Thanks. Not really sure, let's say about 10 minutes only. It is more for stability issues than loosing power for long periods of time.
  4. Hi, I need to buy a battery backup for my UM2 Extended+ but haven't been able to find the specification of the machine. The link is broken in the support site. Does anyone know what spces should the battery backup have? Many thanks.
  5. DGTalic

    Using the maximum biuld area

    Got it. Many thanks!
  6. Hi, I need to print a model that is 198 x 198 x 12 mm but the machine is scaling it down to 195 x 195 x 11.8mm. I have an Ultimaker 2 Extended+ and the build area should be: 230 x 230 x 305 mm I believe the problem is with the firs layer or the adhesion type but can't seem to change its setting. I need to print using ABS. Any suggestions?
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!