poinko

And the same problem width the first layer 0.2 height. The bed is on a level surface. The problem is only in the back right. How do you can only calibrate the rear right side ?, because in the front right there is no problem. Look if there was something on the back that would push up, but there is nothing Help please, Ultimaker moderator, you're my only hope

Try calibration 3 times, with the same error always on the right side of the bottom. "There's a chance that your bed is slightly banana or the thin x/y shafts." How can I fix this problem "banana x / y" ?

help please, the problem persist, and icant print large

Buy a UM2 +, it took a week to 30 hours without problems printed. But now after updating the latest firmware, I have problems printing in the right corner of the print. After 4 unsuccessful attempts, all there, try Bed leveling, glue, Bed leveling again, clean the base, nothing works, follows the same error. Please help Attached pictures of a square test problem where it begins.