Jump to content

Uboofer

Dormant
  • Posts

    1
  • Joined

  • Last visited

Personal Information

  • Country
    US

Uboofer's Achievements

0

Reputation

  1. Just picked up a new Ultimaker 2 a few weeks ago and been very happy with it. Cura is easy to use and I have been successful with all my print jobs. After watching a bunch of you tube videos and reading articles I decided to purchase Simplify 3D. Since purchasing S3D, I have printed a few things and except for one job that I used a raft (because it was small) everything else has had at least one edge with some warping on it. Even one job I tried a brim and noticed warping the part inside the brim but the brim was fine. The filaments I am using are Colorfabb PLA/PHA and Ultimaker PLA and both are running a temp of 200 or 210 and bed temp of 60. I have created a test profile in S3D and set it to mimic the settings in Cura and changing the fan settings to turn on only after layer 6 to maximize adhesion but still getting warping. The thing I can't figure out is if I print the same parts in Cura, I don't have the warping issue. I am using nothing but the heatbed glass for adhesive in both programs. So far all the print jobs have been basically for function so the warping doesn't hurt the part but it just annoying than anything. Is there any settings I should change that will stop this in S3D? I admit I am new to 3D printing and issues like this are all part of the learning curve. Any advise is helpful. Thanks.
×
×
  • Create New...