Hi guys,
This is my first post on this forum and it's about some problems I stumbled across during a project for school.
We need to 3D-print a prothese socket with a nylon filament. (cad model 2,5mm thickness)
We have tried to print it with the ultimaker 2 extended and various settings without succeeding.
The first print failed because the brim warped.
The second print failed because it used too much filament( we changed the cad model because it was bigger than expected). If we had enough filament it might succeeded.
The third print we used the same settings as the second print but a different filament(hestay). After a night of printing the brim let loose.
The fourth print burned so bad that we had to stop the printer.
All prints had in common that they had burn spots and that the brim let loose or warped.
Does anyone know how we can fix these troubleshootings?
Settings
Print 1:
Taulman 910 2.85mm Alloy filament 245°C Extrusion Temperature 86°C Bed temperature
Support everywhere: 20° angle fill amount:+- 40% Brim
Print 2:
Taulman 910 2.85mm Alloy filament Alloy filament 245°C Extrusion Temperature 70°C Bed temperature
Support everywhere: 20° angle fill amount:+- 40% Brim + glue on platform
Print 3:
Nylon filament transparant from Hestay
Same settings as print 2 but different filament and less fill amount of the support + glue on platform
Print 4:
Nylon filament transparant from Hestay
Same settings print 3 but a higher bedtemperature(100°C ) + glue on platform +covering front of the 3D printer
