While trouble shooting my ongoing retraction problem in Cura 3.0.3 I noticed all of the G1 lines, shown below that do not contain an E value. I also noted all of the G0 lines generated to traverse to the next location where extrusion is needed. What is the reason these lines are generated? All of the G10 & G11 lines are present in the program but the extruder does not retract the filament. I have tried .5 to 5.5 mm retract distance and 25 to 55 mm/s speed.
G1 X134.661 Y98.765 E4599.02746
G1 X134.657 Y98.802
G1 X134.655 Y98.814
G1 X134.624 Y99.014
G1 X134.62 Y99.033
G1 X134.605 Y99.093
G1 X134.551 Y99.304
G1 X134.526 Y99.403
G1 X134.493 Y99.496
G1 X134.476 Y99.544
G1 X134.45 Y99.617 E4599.02864
G1 X134.438 Y99.531
G0 F9600 X134.444 Y99.479
G0 X134.436 Y99.417
G0 X134.424 Y99.332
G10
G0 X134.523 Y99.319
G0 X134.383 Y98.349
G0 X133.503 Y98.27
G0 X127.183 Y94.874
G0 X94.381 Y88.453
G0 X93.785 Y87.658
G0 X93.426 Y87.476
G0 X91.228 Y87.322
G0 X90.719 Y87.625
G0 X87.585 Y90.505
G0 X79.533 Y91.925
G0 X79.076 Y91.925
G0 X78.449 Y91.562
G0 X69.973 Y85.991
;TIME_ELAPSED:3552.515232
;LAYER:37
G0 X69.973 Y85.991 Z7.7
THANX Steve
