JFlesburg

No steps display under my motion settings. It showed "current" for X,Y,Z, & E, but had nothing for steps/mm. Is there a tutorial on how to use TinkerGnome? I thought I read that with TinkerGnome, one would be able to have access to settings such as steps per feed, etc. I have not yet found any good information.

The spring loaded tensioners can be squeezed together to manually release tension on the filament in order to easily insert or remove the filament. If I can figure out how to change the steps per feed, I will install and test this extruder. (please bear with me. I am new at this.)

Can you tell me what I need to change the feeder steps to when using this extruder? I have one, but basically it came with no instructions. I believe that it will work well. From my preliminary testing with it not installed, it does not deform the filament anywhere near what the stock knurled wheel does and since both of the driver wheels are engaged with the stepper motor, this extruder should have plenty of control. With the 16:48 = 1:3 reduction, the extruder should have significantly more torque than the original design. Thank you