gurnben

Hey guys, So recently I have started having extrusion issues with Push Plastics filament on my ultimaker original +. Here is a picture of what has been happening: https://goo.gl/photos/zbVacZdinst3HN2g9 I'm not sure if the issue is print settings or what, but I am printing fine right now with my one spool of ultimaker filament, but I have a stack of Push Plastics PLA that I want to use! I can post print settings as needed (I don't want to just copy and paste them all here) but I print at 210 on the nozzle and 60 on the bed and have gotten multiple successful prints before this started happening! Ideas or suggestions? If you have any questions feel free to ask, I need your help to figure this out

I have solved it! It was an issue with the left slider block!

Hey Guys, Well, I'm new here and I hate that I am immediately here with an issue! I just finished building my UMO+ and when installing and calibrating the print head I felt some hesitation in the Axis from Back to Front (honestly I forget which axis that is in this case). I tried recalibrating it with the calibration sticks 3 times to no avail. After writing this post I am going to try again and hope. It is causing the print head to hesitate and move jumpily when I finally activated it during the bed leveling. Any ideas or suggestions? I believe it may be related to the left axes bar as it appears that the pulleys are not aligned with the slider block but I am not sure. I can gladly include picture and video! Thanks!