Jump to content

CME

Member
  • Posts

    3
  • Joined

  • Last visited

Personal Information

CME's Achievements

0

Reputation

  1. Sounds good. I figured out that I needed a fan splitter, and I had one lying around. Works perfectly now. Thanks.
  2. Thank you. I will try that. One more question though. The PTFE coupler in the hotend is burnt and probably should be replaced. Can I use the UMO+ one?
  3. Hi everyone. I've owned the UMO+ for a couple months now, and recently I was able to get an UM2 hotend (the makerspace I'm part of upgraded their UM2). I found Neotko's wonderful guide on how to install it, and decided to test the heater, fans, and thermistor without installing it yet. I plugged everything in, and the heater, thermistor, and the hotend fan (the small one) work great. However, the two print cooling fans act strangely. I can increase the led brightness from the ulticontroller and it turns the fan plugged into the LED PWM port on, but when I turn the fan up to 255 on the ulticontroller, it does not even move. When I only plug a fan into the FAN PWM port, it works. I think this is a firmware issue. I'm using Amadee's firmware builder, but am not very experienced with it. Can someone tell me the settings I should use. If it helps, I have the 2.1.4 board. Thanks!
×
×
  • Create New...