Jump to content
Ultimaker Community of 3D Printing Experts

Pilla

Member
  • Content Count

    15
  • Joined

  • Last visited

Everything posted by Pilla

  1. Thank you for reminding me about the older Cura, rowiac. That seems to work. I got my 3 squares printed nicely by moving the bed up a hair. This bed leveling wizard uses 210 C for the nozzle and 70 C for the bed - higher than my usual. I hope to get a successful test print! If you don't hear from me any more, I succeeded.
  2. I have been having trouble since I bought a new brass nozzle. I replaced the old one with the same type, after over a year of daily prints. Now I have two problems. 1. When doing the Checkup using Cura 3.1, the nozzle temperature never says "checked", even though the nozzle heats to 180C and stays with in +/- 0.5C. (I won't worry too much about that, since it's heating.) The X, Y, and Z-stops and also the bed temperature Checkup just fine. 2. The first layer is not good. I have set the Z-stop, and with blue Loctite for vibrating screws, held it in place, in the right place. The
  3. Version 1.0

    1,047 downloads

    Finally got my new printer to do beautiful work! 30 mm on each outer edge.
×
×
  • Create New...