dezels

answer : "set settings" : -Control -> Motion -> Zsteps/mm: +0200.0 "save settings": -Control -> Store memory Thank you Neotko!!!!

Thank you !!! You made my day!!

Thank you!! It is a square! (not a rectangle anymore) Is it possible to set this settings? Now I am spinning 200 every time.

Control setting: Accel: 4000 Vxy-jerk: 20 Vz-jerk: +000.40 Ve-jerk: 5 Vmax x: 500 Vmax y: 500 Vmax z: 5 Vmax e: 25 Amax x: 9000 Amax y: 9000 Amax z: 100 Amax e: 10000 A-retract: 3000 Xsteps/mm: +078.74 Ysteps/mm: +078.74 Zsteps/mm: +0400.1 Esteps/mm: +0836.0 Photo : (What is a factory reset?) I did : calibration, bed levelling, fine-tuning. Maybe you can see some mistakes or errors in my settings (ulticontroller)

Yes, in Cura I added a new machine, upgrade firmware and checked/reset all settings .

I have some printing problems after upgrading. Last week I bought an “Ulticontroller” and “Heatedbed” upgrade kit for my Ultimaker Original. now I am printing with cura 15.04.6 because Cura 2.1.2 is not working very well with my Ultimaker. After upgrading my Ultimaker Z axis scale is bigger. 15 mm box I checked the jumpers on the Z stepper driver area. The first 2 jumpers installed and the 3rd jumper is not used. My print is better scaled with all jumpers on. (ON-ON-OFF = scale +/- 300% Z) (ON-ON-ON = scale +/- 200% Z) Is somebody who can help me? Thank you!!