Jump to content

FreeBill

Dormant
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    US
  1. Awesome. Thanks for the details everyone. I will try these methods.
  2. I ran a print last night and it caused a serious filament jam. The melted PLA ended up inside the extruder and is caked on the wires coming from the rear. I heated the extruder to 260 with the fans on to try to melt it out, but only the bottom most PLA melts out. I've been really enjoying to 2+extended so far- this is the first issue. Do you think I should take the extruder apart? Any tips for removing the melted PLA? I can't use a torch because of the wires. Thanks!
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!