spalsh

2.1.3 - I managed to resolve the issue; reduced the Skirt Line Count and the Skirt Distance to 0 and then re-loaded the STL file into Cura. Sorted, thanks!

Thanks yellowshark, I'm wondering if it is a Cura issue that its maximum model volume is slightly smaller than the Ultimaker's specified build volume...

Thanks DaHai8, I noted those settings and will bear them in mind for future models; for this particular print, I'm assuming I won't need any support as there are no overhanging areas - it's almost a cube-like shape, 200 x 221 x 52mm high, so it does fall within the build volume specification for the Ultimaker2, which I assume is the maximum model size!

I've set up a model to print within the Ultimaker 2 Build volume dimensions of 230 x 225 x 205 as per the manual. The footprint definitely falls within these dimensions, but when I bring the STL file into Cura at the correct scale, I get a greyed out model. I've tried rotating by 90 deg, but it doesn't help. Is this the correct build volume dimension or should I be working within a slightly smaller volume?