Jump to content

3drepublika

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About 3drepublika

  • Birthday 06/25/1980

Personal Information

  1. Oooo thank you so much. This was huge problem for me.
  2. Hi all, When we printed with 0.8mm nozzle, 0.3mm layer, CURA set temperature to 240 C. After some time the printer went out of material so the change of material roll was necessary. We pressed pause, so that the printing process could be resumed after the new material roll was inserted. Than we pressed Change material and the printer made announcement for reversing material mode. Then we pressed ready and the printer just kept on doing this strange loop of cooling and heating the nozzle instead, like it had some kind of conflict inside the program. The inserting material mode could not start because of this loop. I assume this has happened because the temperature was set to 240 C in CURA Print Job settings, but the temperature option in printer insert PLA material settings is set to 210 C by default and could not be corrected. I have tried this two more times with new prints and same things is happen.
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!