Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Hallo Fridolin,
ich habe einen Ultimaker 2+. Der hat jetzt etwas über 9000 Stunden reine Druckzeit auf dem Buckel. Bis jetzt noch kein Ersatzteil benötigt. Selbst der PTFE Coupler ist noch der erste. Drucke allerdings fast nur PLA. 1500 Stunden sind alse Peanuts.
Ich habe ein Bahnbetriebswerk im Massstab 1:87 konstruiert und mit meinem Ultimaker 2+ gedruckt. Nachstehend nur ein paar Bilder. Mehr, siehe hier:https://www.stummiforum.de/viewtopic.php?f=180&t=171433
Hallo Christian,
die Wandstärke (0,4mm) ist zu gering. Erhöhe einmal die Wandstärke um 0,05mm bis 0,1mm. Dann müßte es funktionieren. Oder nimm eine kleinere Düse.
Gruß
Gerhard
Hallo Reborn,
schau mal hier https://stummiforum.de/viewtopic.php?f=180&t=171433. Alles mit Ultimaker 2+ erstellt. Und zur Genauigkeit: nach fast 9000 Stunden reiner Druckzeit, ohne ein Ersatzteil benötigt zu haben, kommen solche Ergebnisse:
Es gibt nicht die besten Einstellungen. Kommt immer aud deine Teile an. Unter diesem Link kannst Du Dir mal die Möglichkeiten des UM2+ anschauen. Diese unterschidlichen Teile benötigen halt unterschiedliche Einstellungen.
https://stummiforum.de/viewtopic.php?f=180&t=171433