lcrrick

I am the kind of person that upgrades to the newest software avail. I am using this on MAC OS I downloaded CURA 3.1 and tried to use it with my UMO+. As soon as I started the software it asked what printer I was using. I put that info in and it wanted to do a system check. Everything worked in the first window as it should..... then I thought i should do a bed level with the new software..... that is when it got weird. It went through the leveling process as usual BUT it was hovering 10mm or so higher than the print bed. I went back to v2.3.2 and it leveled out perfect. ANY THOUGHTS? please help.

I have had a UMO+ go from great prints to Extreme under Extruded overnight. I have had great success with the trouble shooting area of the Ultimaker site in the past. NO LUCK this time. I have tried everything on there as well as some other suggestions from the "google" I have only messed with PLA and Carbon Fiber What I have tried with NO change: 1. Change Settings Hotter extruder and cooler extruder 2. Change material, different PLA, then Carbon Fiber 3. New extruder tip (three different ones) 4. New insulator 5. Whole new Hot end 6. Cleaned Feeder(bowden) tube(did not replace) 7. Hotter bed (didn't figure that would do anything and it didn't) 8. Leveled the bed countless times...... I am not sure what to try next. It seems that If I run at the very top of the temp spread for PLA it is a bit better but still no where near the quality of the prints this unit made when new at lower temps (i.e.: 225c vs 200c when new) PLEASE help if anyone has any suggestions.