Jump to content
Ultimaker Community of 3D Printing Experts

killerpig

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    CA
  1. I haven't used my printer in a while but recently tried to and I'm getting constant maxtemp errors when preheating the nozzle. It goes up at a steady rate of about 2-3 degrees per second until it reaches around 170deg, then it starts jumping up by 10 degrees per second until it gets a max temp error. Does anyone know a possible cause of this problem? Is the temperature sensor defective?
  2. I accidentally broke the thermocouple and am trying to find where I can get a replacement. I live in Canada and found this website http://shop3d.ca/product/pt100-b-sensor/ but am wondering is this the same thermocouple used on the UMO+. It looks the same but the webpage only says it is used with Ultimaker 2 family. Side question does anyone know a good place to get spare parts in Canada?
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!