Hello,
I was in the process of printing a ±30 hour print and it stopped 5 hours away from finishing.
I noticed the nozzle is blocked so i tried to apply the atomic method to clear it up but it was unsuccessful.
Every time I put the filament in trough the top it seems like it doesnt reach the nozzle and i cant proceed with atomic method. I tried using acupuncture needles and sewing needles from the bottom but that was unsuccessful as well.
I am a bit frustrated, since it is an important project for me, and I tried everything. At this point ordering a new nozzle would not help because it would take too long.
Any tips would be greatly appreciated.
PS: I should mention that I am using a hemp based biodegradable plastic filament, which we make ourselves. Printed lots of big and small prints with it, never had a problem like this; the atomic method always seemed to do the job.
Regards,
Alex.