Jump to content


  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
  1. Would you mind sharing the solution so others who have the same problem know how to fix too?
  2. I don't know how many hours it has but it will be a lot, and I haven't changed the PTFE part, probably ever. I have done an atomic pull. Yes, it was successful and I was able to easily push filament through manually.
  3. Any ideas on how to fix this? I've tried 'fishing' at the nozzle to remove any blockages, came out fine and I can manually push filament through without problems. Also, I tried calibrating the print bed several times with no change. Print settings: Layer height - 0.06mm Print speed - 60mm/s Material - PLA Temperature - 210° Ultimaker 2 extended
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!