domagojhack

I am printing casings for electronics. With my new Ultimaker 2+ I made 3 successful prints. However, when trying to print 4th time my Ultimaker2+ just turned off mid-print. My previous prints differed in material, settings and nozzle size so I doubt there is problem in settings. Current model I am trying to print with PLA and 0.8 nozzle (with standard fast print settings available in CURA) and it fails during first layer print (no error just turns off). While I am writing this post I am trying to print this model again. Any ideas? Cheers, Domagoj.