3DTCI

Hi Thank you for your help, 👍

Hi, I have just installed the Ultimaker 2+ connect firmware 1.1 , and when I load the filament , the feeder loading speed is not fast as it should be , it is loading the filament very slowly as if it is loading filament for printing anyone can help?

I have this problem with UM3

The previews are correct in both windows 7 & 10

I think it is windows 7 that is causing the problem , I tried to change the USB first and it was not the USB issue, then I tried the same project on windows 10 and the slicing given time was 2h 50min , while on windows 7 the time was 39min only , noting that I used the same profile setting on Cura 4.2.1

in the preview the slices are complete , and it shows the whole object , and the display says remove object from build plate At the moment I can't share the file , as I am not in front of the printer

it look like the print is finished , and I am printing via USB

Thank Smithy I am using Cura 4.00 ,to print with UM3 refurbished, I tried the default profile normal without making any changes on the settings , and the job starts normally , but the printer stops printing in middle of job, the job ends at the middle of the item and the build is not completed

I am using Cura 4.00 , and the UM3 stop printing at middle of the build, I am using the cura normal profile sitting with out any changes

Hi I just installed a new UM3 EXT and the print head is not moving to the right distance so that it can reach the white plastic piece which used for raising the BB core, I have a video but I can't upload it as it is .mp4

Hi Smithy Thanks it works, the cover is latching now 👍

thanks Smithy for your reply , the door hinges are working good , but the magnet is not latching , so I have to use tab to keep the door closed

Hi I removed the silicon nozzle cover, after I did that , the cover door no longer close and the magnet on longer latching I did nothing except that the silicon piece is not fixed , any one knows what to do for the magnet to latch ?