[Cura 2.5 and surface mode]

I was printing some parts in surface mode. In 2.4 no problems, In cura 2.5 it doesn't slice, no error but print time 0 minutes.

The settings are imported from cura 2.4 where they worked. Even if I reset the settings, and choose surface mode, the problem stays.

[Cura 2.3 - Not using full print area]

Tried al settings of losing brim/raft/skirt in cura 2.3 didn't succeed to print larger then 19*19.

Tried cura 2.4 set build plate adhesion to none, no problem in printing 20*20 thnx.

[Cura 2.3 - Not using full print area]

The max build volume I'm getting after these instructions, is only 190*190*??? Not the full bed. I'm trying to print a 200*200*55