sntinel

Selling my two Ultimaker 3 machines. Great machines but I am moving on to SLA printing. Have not used them in over a year but I have tested them and they are still operational. May need to be lubricated. Prefer a local buyer in Los Angeles area that can pickup locally but can ship (Buyer pays shipping costs). I have the original box for one of them. Asking for $4200 + Shipping. Will only ship within the continental 48 states. Thank you Ultimaker 3 #1 - GeckoTek Solid magnetic bed mount with removable metal sheet -BondTech Dual Drive Extruder installed - .4 AA Nozzle lightly used - .25 AA Nozzle (used once) - .4 AA and .4 BB (Installed) used - Printed Solid Top and door enclosure kit Ultimaker 3 #2 - BondTech Dual Drive Extruder kit (Not installed) - (Two) .4 AA Nozzle (New) - .4 AA Nozzle and .4 BB Nozzle (Installed) used - Printed Solid Top and door enclosure kit BONUS - Alot of new/used filament including a 5kg White PLA Spool from Matterhackers. Other spools from Matterhackers, Atomic Filament and Ultimaker

Thanks everyone for the advise. I'm not too skilled at soldering so I just ended up buying a new replacement. That said, I will practice my soldering skills now that I have this spare board ;)

Instead of buying a whole new heatbed for $180, is there an adhesive I can use to repair this?

Thank you! It allows me to change it but wasn't sure if it would actually force it to print at that resolution.

I recently purchased this material and it works great, but when it's loaded, it limits Extruder 1 to print at .15 or .20 layer height. I could not find anything where it stated that you could only print at this layer height when using the breakaway material. If I switch extruder 2 back to PVA or PLA, I'm able to print at higher resolutions. I just want to make sure this is the case when using this support material. Thanks!

I recently had this happen to me over the weekend and coincidentally right after I updated the firmware too. Fortunately, after I try to print the part again the 2nd time, it works fine and successfully completes it. I may just reset the printer back to Factory defaults and try to manually level it and see what happens. Then after a few prints, I'll have it autolevel again and try printing again to see if the error appears.