SigvardsK

Hi, We're experiencing the same issue as as above just on our S5 printer. We connected the printer via ethernet and locally we can see and manage the printer, but when we try to connect to it via Cloud (or add printer via Cloud) the endless loging in begins. Added our Log files. It looks like a similar issue with the network on our side, but just to confirm, maybe someone can check the log file? Thanks a lot! Sigvards Log_S5.zip

Ok, thank you for your suggestions. I`ll try your recommendations and see what happens.

Yes, the feeder is set at the middle setting. Ok, I`ll try your suggestion. Thank you!

Yes. This is the Ultimaker TPU 95A filament. I see. Ok, I`ll try your recommended settings and let you know how it looks like. Regarding the 145% material flow, I read here https://ultimaker.com/en/community/18953-ninjaflex-uneven-extrusion that for elastic materials, such as NinjaFlex or TPU, higher material flow is necessary. But then again, I may be wrong.

Hi, I am new to 3D printing. Just started couple of months ago and currently have been experimenting with different materials. (ABS,PLA,Nylon,TPU) With most of the materials I have understood the basics and the prints are quite good (for a beginner, as I have been told), however with TPU I have yet to fully understand its specifics. Below is a image of TPU print (not finished) and it seems to look like under extrusion. The following settings were applied: L/H - 0.2mm W/T-1.05mm T/B-1.2mm Infill - 50% Print Speed - 30mm/s T/B - 15mm/s Travel Speed - 120mm/s Material flow - 145% Fan Speed - 50% Temp. - 230C Bed temp. - 70C Am I correct to assume, that this could be the case of under extrusion? If so, what would be the possible solutions for this matter? Thank you already in advance!