Jump to content

MechDesigner

Member
  • Posts

    36
  • Joined

  • Last visited

3D Print posted by MechDesigner

  1. Newco coffee cup stencil

    Newco coffee cup stencil

    789 downloads

       (0 reviews)

    0 comments

    Updated

  2. Switch removal tool

    This is a tool to remove a switch from a sheet metal panel

    740 downloads

       (0 reviews)

    0 comments

    Submitted

  3. bad looking bottom of print

    My first post new to 3d printing.
    My name is Frank I work in ST. Charles MO.
    I received our Ultimaker 2+Extended last Monday.  I am impressed with most of the print quality.  The Cura software is easy to use.
    After learning a lot great information this forum. I have a few good prints, but the bottoms of the parts are very rough.
    I ran the part on its side and all the bottom surfaces are pretty rough even where there was no support,
    I used support where touching the print bed.  If I would have used the support everywhere I think the support between the ribs would be hard to remove and would look the same.
    Is there any way to avoid the bad bottom surfaces, see attached pictures.
    Also how do I extract all the printer settings so I can paste them here
    Abs,
    printer bed @95
    Thanks
    Frank

    801 downloads

       (0 reviews)

    0 comments

    Updated

×
×
  • Create New...