Jump to content

Sai

Dormant
  • Posts

    1
  • Joined

  • Last visited

Personal Information

  • Country
    GB

Sai's Achievements

0

Reputation

  1. Hey, First-time poster, and new to the UM community. I've had no problem with my UMO+ for a week or so, it's pretty new, and I've been pretty happy with it asides the one or two things that some guides shave helped fix. I finished a print no more than an hour ago, came out fine. The printer went back to the home position and I preheated to start the next part of the print. When starting the print, nothing is coming from the nozzle at all. If I let it run for about a minute, nothing happens still, so I'll abort the print with Cura and auto home. I'll push the bed away from the nozzle and then filament starts pushing out. After this, I put it on preheat again, which is still pushing filament out of the nozzle. So now I'm a bit puzzled. Is there a blockage that I need to clear or something else? The filament doesn't look like it's been ground and there's no plastic coming out anywhere above the nozzle. Any help would be greatly appreciated, and I hope I got this in the right forum.
×
×
  • Create New...