Jump to content

limburgmetaal

Member
  • Posts

    34
  • Joined

  • Last visited

Personal Information

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

limburgmetaal's Achievements

9

Reputation

  1. that makes sense!, thanks, never tought about it this way. Will try it over teh weekendZ Thanks!
  2. Hi Geert, Thanks But the "flat" bit on the bottom is the marking area and the hole concept of the print. On this you can write that it is "a 9mm Drill" and store it. If you need the drill you will have it right away and don't need to measure the tool anymore. The two arms are a bit spring loaded to hold the "flat bit"
  3. i tried this, but is not giving the result that i was looking for.
  4. I have made some labels to mark my milling tools (SK40) as per picture The material i used is PLA by Ultimaker. Initial it is flexile, but after a few month the arms break. Who can recomend a better material?
  5. Hi I have a ultimaker3 and work normally fine. but i have no a problem that the PLA core is not feeding anymore. Initially i thought there was something with the reel as the feed wheel was grinding in the core. Changes the spool and again it happend. 2 Spools and 3 product that on the exact same spot start to get faulty. The feed unit has been opened to check, cleaned of small dust, knurling on feedwheel is fine, main gear wheel seems fine. infeed of new material goes smooth Anyone who has a clue?
  6. It there someone who succeded in making a working wrench? i have tried several on the web found but non was working the offset possiblity was used and that made it a little bit better, but still not working below picture are top and bottom side bottom side is very poor!! Machine UM3 Nozzle 0.4 Layer height 0.1 material tried: PLA and ABS Support either PLA or PVA with the ABS
  7. Version 1.0

    953 downloads

    I needed a testing stand to check the roundness and the swiffel of some items. The higher support is Multi purpose, you can either mount the bearing support or the pin for centering in the center hole of a shaft. Height adjustment is easy so that you can line this with the fixed bearing support
  8. Version 1.0

    984 downloads

    new plexiglass support for my UM3 hood
  9. i have printed with this reel of ABS before and worked fine, but for some reason there is a poor cohesion between the lines result a, brittle part that is not good Table 60° Extruder 220° Fan Off layer height 0.2mm speed 3600mm/min Nozzle 0.4 anybody any idear?
  10. I have both cura and s3d, if i can help than let me know
  11. have you tried to make the same print with an other slicing program as well cura and s3d? if so this will eliminate the error in a Gcode
  12. Can you glue 2 pieces of a pla printed part together? I tried to use Loctile 415, but that is not working
×
×
  • Create New...