dahollings

Hello, First time posting on the forum. I have UM2+ that I have been playing with for about a month. I tried out the adhesion sheets with PLA and had similar problems as above with too much adhesion. The part had a fairly large footprint and it simply would not release. Eventually I was able to scrape the part off. Is a water soak the best option for removing the damaged sheet (and adhesive)? I tried acetone, IPA, and goo-gone with mixed results. Eventually I was able to remove most of it but it took a lot of time and plenty of elbow grease. Is there a "recommended" procedure for removing the sheets?