Jump to content

sindrejl

Dormant
  • Posts

    1
  • Joined

  • Last visited

Everything posted by sindrejl

  1. Hello, I had my Ultimaker 2+ for 3 weeks now and it has been constantly spitting out perfect prints. But I heard so much positive stuff about simplify3d so I wanted to test that software to get more control on more difficult prints. With simplify3d everything got messed up, it never wanted to start printing in the right height, not enough filament extrusion +++ a total mess no matter what I put the settings on. So I went back to Cura and tried a print, but now the printer always starts to extrude 1mm higher then the bed leveling Ive set so the first layer naturally wont stick. Have tried full reset, have tried new firmware but nothing helps. It always starts printing too high no matter what i do. anyone have any tips to make the printer work again? wont touch simplify3d again thats for sure
×
×
  • Create New...