Jump to content

vmuddu

Member
  • Posts

    12
  • Joined

  • Last visited

Everything posted by vmuddu

  1. Hello Everyone, I was wondering to ask if anyone tried printing Ultimaker Airplane. When I was trying to enter the values for the top/bottom speed. My cura says it is unable to slice. However, the settings from ultimaker were: Quality Initial layer thickness 0 Initial layer line width 100 Speed Travel speed 170 Bottom layer speed 15 Infill speed 0 Top/bottom speed 0 Outer shell speed 0 Inner shell speed 0 Minimum layer time 10 I have attached an image which shows the problem I'm facing while entering these values. Any help is much appreciated. Thank you in advance.
  2. Many thanks for your response. I tried reducing temperature, but no luck ! However, I'll try to use the 'Tweak at Z plugin'.
  3. Hi everyone, I am trying to print vertical axis wind turbine, but my print fails at a certain height. I've used the recommended print settings for the TOP WING. Can anyone help me how to overcome this issue? Many thanks in advance. Thank you Vik [/media]
  4. It's just the user error. But the filaments needs to stored in a cool and dry place in order to have a high quality prints.
  5. Hi, Thanks a lot! I removed the bowden tube off the feeder and i removed the material. Once again thank you. You saved me a lot of time! Cheers Vik
  6. Hi, Thank you for your response. I tried the same method as pulling the bowden tube off the feeder as I did it to the nozzle head, but the tube doesn't seem to come off. Is there a way to remove the tube off the feeder?
  7. Apologies for not being specific about the material. It is PLA Glow in the dark green. I've tried to take off the bowden tube from the nozzle head, but I could only pull off a little bit of the material, then again it got stuck in the tube and thereafter i'm unable remove the material.
  8. Hi Everyone, I have an UM2+ and my material is stuck inside the bowden tube. I tried several methods to remove it out, but failed to do so. Can anyone help me out to overcome this issue? Many thanks in advance. Vik[/media]
  9. Version 1.0

    746 downloads

    This Arm printed on behalf of e-Nable Australia.
  10. Hi everyone, I am currently facing issues with a tall object of 135mm height and 30mm thick. The part falls down when it reaches to the top level. Do anyone have any advice in regards how to print the tall object without falling down. I used brim and raft, but both doesn't work. Many thanks in advance. Vik
  11. Hi Everyone, I'm a newbie to 3D printing. I've tried printing small marvin key chain, but i faced problems when i was using support structure. Based on the talk forum, I changed my settings and tried printing it without support structure. The first marvin on your left hand side was printed without support. Rest of them were with support. First marvin settings: Layer height :0.2mm Infill Density : 30% Shell : default Print speed : 20 mm/s Travel speed : default No support Brim Cura 2.3.1 Please rate the print quality . Also, I'd love to take suggestions if i can improve the print quality. Many thanks in advance. Cheers Vik
×
×
  • Create New...