Jump to content

BenSlos

Dormant
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    DE
  1. Dear UM-Community, this is my first post in this forum so just correct me if I am doing anything wrong. At the moment I am trying to print some parts of my bachelorthesis in architecture. And the prints are failing all the time :(I am using the Ultimaker 2+ with cura 2.3.1 Can you maybe give me a hand? This is my model: I am printing it upside down and face some different issues: 1. As expected, the printer got problems with the overhang geometry The picture shows one of the first layers, which are looking good during printing but any higher layers are failing. I already tried cool temps slow printing and high speed fans (195°C, 20mm/s, 100%) no good results. 2. Cura wants to print a plate in the middle of the model, which is not contained in the original geometry. Support structure is disabled. 3. When uploading the .slt first time to cura, a small part of the model is cutted of at the buildingplate (few mm). Is there any tick box I am not able to see? Generally I am trying to avoid the support structure, because I am afraid of the damaging the model when trying to get rid of the support structure after the print is finished. I hope you can help me! Thank you very much in advance. All the Best Ben
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!