Jump to content
Ultimaker Community of 3D Printing Experts


  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
  1. Hello everybody, I don't know why, my um2e+ recently started to fail at the end of the prints. Almost every time. The printer print perfectly until the last layer, and then purge the head on the print, causing a "blob" of plastic on top of it then go to the zero position without moving the z axis down, causing damage to the print, an it also take back the filament way to much in the bowden tube, wich forces me to re-feed everytime the print head. It's appening very often since then and I'm out of ideas : I did a factory reset Installed new
  • Create New...