Jump to content

myRobot

Member
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Field of Work
    Other
  • Country
    US
  • 3D printer
    Ultimaker 3

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Ive been having trouble getting my Ultimaker 3 to print. Through many hours of troubleshooting I discovered wires in the print head had melted together. It was on the capacitive sensor board in the middle of the fans shown below. I need to replace the whole board or if I can get just the wires themselves.
  2. I have this issue and haven't been able to fix it. I did factory reset multiple times.
  3. I have had this problem recently where the print head will not come out. I ultimately end up breaking the "aluminum cooler" I think it is called. In the past my print heads have become so clumped with I filament I ordered 2 brand new print heads.
  4. Is it possible to use 1.75 filament in a 2.85 printcore?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!