Jump to content

Cocogana

Dormant
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    JO

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. yep the title was misleading but I wrote down heating cooling and it got me here XD I solved the problem by updating the firmware of the ultimaker 2, that fixed the issue, but then I stumpled upon a different issue which was the retraction of the filament, was too small so it didn't print well at the start, set the value of the retraction value to make it to 20, that will start printing normally with filament sticking out of the nozzle
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!