cube1us

I tried my full post with more info, but it kept insisting I was violating house rules, so here is a shortened version. 1. Installed Cura as bundled with a Monoprice Maker Select V2 printer, version 15.04 (I think 15.04.2). Since I already had Arduino drivers installed, I cancelled that part of the install. 2. Started using the software, which seemed to work fine. However, within about 2 days, with no other system changes, I started to see random reboots. They never occurred when I was using the system, only when it was idle. (deleted Windows bugcheck info) 3. I uninstalled the software, disabled anti-virus and so on, but the crashes continued to occur. 4. I then restored to a Windows "system restore point", and waited a day, with no further crashes. 5. Figuring that maybe the issue was caused by telling it to not install the Arduino drivers, I reinstalled the software that was bundled with the printer, allowing it to install the Arduino drivers. It seemed better, however, a week later I was in the same boat. 6. I again reverted back to the restore point I had made just before the reinstall, and started using the software on my 32 bit laptop instead. After 9 days, I felt the system was again stable. 7. I did some other software updates, created another system restore point, downloaded Cura 2.3.1 X64 and installed it (without deselecting the Arduino drivers). Things were OK for about 4 days, and then: So, I again reverted back to the restore point once more, and am now in a 9 day "holding pattern" before I do anything else, to confirm that the issue is related to the Cura install. Any suggestions? Anyone else see this kind of problem? Thanks.