Jump to content

ThomasNF

Dormant
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    DE
  1. Hello all, I have an ultimaker 2+ since yesterday and started with a test print of a housing for Electronik .The Part is about 200 * 120 * 130 mm. 130 mm is the height. Printing went well until about 40 mm height. The Problem is, that the nozzle hits the Surface of the support structure sometimes and at least the support was pulled out by the nozzle. The GCode is generated with CURA 2.4. Is there a way to avoid that Problem? I wonder if it is a software or a hardware Problem. Thanks for your help Thomas
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!