Jump to content

nonmalus

Dormant
  • Posts

    2
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker 3 (Ext)
  • Country
    DE

nonmalus's Achievements

0

Reputation

  1. I got the same message after upgrading the firmware. Till yesterday all works fine. But now I need 2-3 starts before the printer is working well. Sometimes the message came - sometimes not. The glass is clean and the nozzles too. That would came with the update I guess.
  2. Now I am an owner of an Ultimaker 3Ext for 3 month. The prints I made are very nice and will be better and better by profile optimizing. But now I have no idea: I want to print a small piece with Ultimaker Nylon black on my UM3ext. Big pieces were printed without any problems but small ones not. I am using Cura version 2.4.0. I got some tips by a IGo3d technician but the printed optic is not the same like PLA. In the case of PLA it looks great. Here the print settings: Layer 0.1, Linethickness 0.4mm, Infillthickness 0.5mm, Wallthickness 1.2mm,Infill 20%, Headtemp: 245°C, flow 100%, Retract activated, Retract 8mm, Printspeed 30 mm/sec, Cooling 40%. [/media] The outer diameter is 12mm, the inner diameter is 10mm. The piece is a snap in bracket. Did you have any Ideas to optimize the print settings for a smooth surface without wrinkles spider ropes.
×
×
  • Create New...