Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up

Suzana

Member
  • Content Count

    6
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    RS

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. It has 1,192 hours of printing time on it for the few years I had it- really wasn't used all that much. I'm also giving a few materials that I have for it, a bit of PLA and some of wood plastic and ABS materials that I have. My asking price is 2,900€ + shipping, (I'm from Serbia) The price is really a good deal, but I'm willing to talk. Pictures can be seen here: https://www.kupujemprodajem.com/big-photo-94311325-1.htm Selling reason is that I don't need such a big printer for my needs (mostly print minis). Everything is working and fine 🙂
  2. I have an Ultimaker 3+ This morning I started having issues that the second nozzle was draging on the print while the first nozzle was working, so I aborted the print, did manual leveling, then calibration of X Y offset, and then suddenly the noise started appearing when the printhead would go to 'home' corner. Whilst, the levelling and calibration not fixing the problem.... I tried looking clos to see why it makes that sound but I didn't come to any conclusion? video: https://drive.google.com/open?id=1JfYDyiKz1JK1MYdZfWak607hywNijqfk
  3. No worries. To show the picture, make sure you have put in the Http:/ or HTTPS:/. It does not like the generic www.yourlocation.com. But, having seen the pic, I can say, with a lot of certainty (and that ALWAYS gets me into trouble) is that your tension on the feeder is not correct.I had that happen a lot. Check here, the first pic has the same issue: https://ultimaker.com/en/resources/36111-material-is-ground-down-by-the-feeder Be aware that different manufacturers of filament require different tensions sometimes as well as different types. And make sure your roll has not binded against itself (crossed lines, etc) and has a free, easy pull off the roll. Good luck!! Thank you for the help!
  4. I have added a picture but I don't know why it's not showing :s http://tinypic.com/r/20kw5mx/9
  5. P.S. and now the nozzle's seem to be clogged. How is that possible, besides the temperature being wrong, which it isnt?
  6. Hello everyone. I have a Ultimaker 3 extended, and something really weird happened. I started a print, which worked normal for 3 hours, then I left home and came back in 6 hours, and it seemed like the material stopped extruding hours ago and didn't print much further after the three hours. The PVA extruder looks burnt, and the PLA had material all over it like- completely covered. I wanted to check if the material got stuck because of bad temperature, however I knew that I've set it up right, and then when I unloaded the materials I saw that they we're BOTH bent in and a little broken, right where their end was getting into the feeder (I'll attach a picture.) I really can't figure out how and why this happened, especially how it happened to both of the materials... Does anyone possibly know the cause?
×
×
  • Create New...