Jump to content

Noamo30

Dormant
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    US
  1. I have a problem that I believe is caused by my Z offset. I have it set very high to compensate for an auto bed leveling sensor. (2.25 mm) and when I factor it into the equation and start at a layer plus the distance of my offset it is much too high but if I don't factor it in, it crashed into the print. I used a layer height of .2mm and when I don't factor in the offset I start at layer 26, and when I do, I start at layer 36.
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!