Jump to content
Ultimaker Community of 3D Printing Experts

joshikirsch

Member
  • Content Count

    2
  • Joined

  • Last visited

Everything posted by joshikirsch

  1. I'll definitely try that out! Looks like those caps could hold them in place. I'll report the results. Thank you! I've already thought of that - problem is, that those axles haven't seen a drop of oil since they got replaced with polymer bearings - which were to be ruined if they got lubed. Even cleaned them of with acetone in advance to re-installing. Have a nice day, Joshi
  2. Hey guys! I'm quite new so please don't blame me, but I'm into deep problems with the Ultimaker 2+ in our FabLab (Bad Windsheim, Germany). The axle-rods (the thinner ones that go through the printhead) tend to get loose from the black plastic mounts and then knock on the acrylic side of the case. This furthermore causes another huge problem: Sometimes the rods fail to touch the end switches after printing and when homing the printhead. -> ERROR: X/Y-switch broken. The printhead can be moved with a small but consistent resistance. What we've done so far: - checked belt tension and al
×
×
  • Create New...