Jump to content

bayners123

Dormant
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

About bayners123

  • Birthday 12/08/1990

Personal Information

  • Field of Work
    (Product) design
    Engineering
  • Country
    GB
  1. I've got an Ultimaker 3, and I've been trying to use it with PLA in extruder 1 and PVA in number 2. However, I've found that when trying to do a print that uses both nozzles, both extruders never extrude for the first few minutes. It's almost like the device forgets to wind forward the material to compensate for the retraction at the end of the last run.It's not that the cores are clogged because both work fine when they're the only core printing. The problem only occurs when I'm set to use both cores in the same print. I've compensated for this by manually moving the material forwards before each print, but why does this happen?
  2. Just for anyone else finding this thread, I also had this problem and updating to the latest firmware also fixed it. Thanks!
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!